Wiring System Engineering Lead - HV and LV Harness

Key Responsibilities :

Leads team of system engineer, translation of EE system architecture into wiring logic and design rules within Capital and downstream Built-to-Print deliverables. Provides functional alignment and release governance to ensure BTP suppliers deliver harnesses that meet system intent.

Roles & Responsibilities (Not limited to)

• 9+ years experience Lead Ground Topology Overview for Ground Points, Circuit Names, Device Names, Definition of Dirty/Clean
• Lead Network Topology for CAN-BH/C, Devices, Harness Family, creating Network Topology, CAN Block P/N's and get network approval from STLA network team.
• Lead for Hi-Current Functionality by creating High Current Topology, 8mm+ wires, devices, wire sizes, wire types, wire length and resistance check to meet system requirements
• Lead Device Topology by creating and maintaining device topology in Visio.
• Lead in creating and maintaining inline topology
• Lead in reviewing with PDC Fuse tree engineers (STLA)
• Lead in creating and maintaining bulletin tracker, determine bulletin effect, provide systems impact to PC and supply bulletin tracker to DR.
• Lead in Developing Complexity Chart
• Lead in create maintain device transmittal / Interface tracker (Fink list) through SYNC 3 and Provide list to PC/DL/DR for program reviews and PMT.
• Ensure Device Transmittal / Interface completeness / accuracy, Loads, Special Requirements, Terminal plating, connector p/n, pinout, One-ended circuit check, Yellow connector check, obsolete connector check, disassociate device Interface from other carlines and interface sign-off
• Maintain DTCR / Interface tracker (after Release 1A close), provide tracker data for Program Reviews to PC/Systems DR/DL.
• Meet with PC, CoC to obtain Interface / DTCR approvals.
• Lead for Sales-code device pins by assigning device pins with feature codes.
• Lead for Inline by creating and submitting CSR forms to CoC, creating inline list file (X/Y-NUMs, Male/Female, connector p/ns, description, etc), Approve inline pinouts and creating inline device transmittal (add special requirements. and terminal plating).
• Lead for Wire Gauge Selection by providing initial wire sizing and approving final wire size.
• Lead for EE Systems Design Reviews by reviewing sub-systems.
• SDP / Schematics design in Logics.
• HV Cable Circuit design on 2D: Logical and Physical.
• HV 2D Drawing: Knowledge about General Standard Guidelines, Packaging guidelines and safety guidelines for transporting, precautionary steps for laying onto vehicle.

Qualification, Experience and Competency requirements:

Preferred Education

• B.E./ B. Tech in Electrical/Electronic/Automotive Engineering with Automotive Industry experience in Wiring harness System Engineering.